Whether in the toilet or in a swimming pool, it from time to time occurs that the Motorola Moto E6 is slipped into the water. Even so, it isn’t because a mobile phone has fallen into the water that it is unavoidably dead. In truth, it is possible to redo an Motorola Moto E6 that has fallen into the water. To accomplish this, it is necessary to respect specific steps. People typically have bad reflexes and this is what can degrade the Motorola Moto E6. We will 1st see the methods to be taken after the Motorola Moto E6 has fallen into the water. We will see in the second place the common errors that a good number of people make.
Steps to follow in cases where your Motorola Moto E6 fell into the water
If perhaps you need to restore your Motorola Moto E6 in operating order, we recommend that you follow the steps listed below.
Do not try to turn the Motorola Moto E6 back on after getting out the water
The first thing to do when the Motorola Moto E6 has fallen into the water is to turn off the mobile phone. In truth, in cases where it didn’t switch off, turn it off without doing any other tricks. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Motorola Moto E6 is started and wet, you could make a short circuit and consequently toast the mobile phone.
Remove detachable components
Once the Motorola Moto E6 is out of the water and switched off, it will have to be disassembled to the maximum. Meaning that it will probably be necessary to remove the shell, the SIM card, the SD card and the battery if possible. Once performed, put all of these things to dry and proceed to the following step.
Aspire the water that is in your Motorola Moto E6
Employing a straw, you must suck up the water that is contained in your Motorola Moto E6. For doing it, you just have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Motorola Moto E6, you will have the ability to start drying it.
Dry the Motorola Moto E6
The fourth step is to dry the mobile phone. For this, we suggest you to put it in front of a ventilator a number of hours. Prevent using procédures that cause the mobile phone to heat up or damage the mobile phone. Once it is done, we suggest you to leave the Motorola Moto E6 in rice for 24 or 48 hours. The rice will consequently absorb the wetness that remains in the Motorola Moto E6.
Reassemble the components and turn on the Motorola Moto E6
When you have completed the prior steps, your Motorola Moto E6 should be dry. So now you can make an attempt to turn on the Motorola Moto E6. If this does not do the job, we suggest you to hold out a few days or to bring the Motorola Moto E6 to a repairshop.
What should not be done in cases where the Motorola Moto E6 has fallen into the water
You will find a number of stuff not to do when your Motorola Moto E6 has fallen into the water. The 1st is to make an attempt to turn the mobile phone back on just after. This can destroy the Motorola Moto E6. Following, it is highly suggested not to use a heat source to dry the Motorola Moto E6. Without a doubt, techniques such as oven or hair dryer heat the components and may degrade them. At last, to get the water out of the mobile phone, do not shake it. In fact, it could also damage the Motorola Moto E6.
