Whether in the toilet or in a swimming pool, it occasionally happens that the Moto E6s is slipped into the water. Nonetheless, it’s not because a mobile phone has fallen into the water that it is unavoidably dead. Certainly, it is possible to redo an Moto E6s that has fallen into the water. To do this, it is required to respect particular steps. People typically have bad reflexes and this is what can deteriorate the Moto E6s. We will 1st discover the techniques to be taken after the Moto E6s has fallen into the water. We will discover in the second place the classical mistakes that a large number of people make.
Methods to follow if perhaps your Moto E6s fell into the water
In the event that you desire to restore your Moto E6s in operating order, we advise that you follow the steps listed below.
Do not try to turn the Moto E6s back on after exiting the water
One thing to accomplish when the Moto E6s has fallen into the water is to switch off the mobile phone. Certainly, if perhaps it did not switch off, turn it off without doing any other tricks. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Moto E6s is switched on and wet, you may make a short circuit and consequently toast the mobile phone.
Remove detachable components
Once the Moto E6s is out of the water and switched off, it will have to be disassembled to the maximum. Meaning that it will be required to remove the shell, the SIM card, the SD card and the electric battery if possible. Once done, put all of these items to dry and proceed to the next step.
Aspire the water that is in your Moto E6s
Using a straw, you need to suck up the water that is contained in your Moto E6s. For this, you only have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Moto E6s, you will be able to start drying it.
Dry the Moto E6s
The fourth step is to dry the mobile phone. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using techniques that cause the mobile phone to heat up or damage the mobile phone. Once it is finished, we advise you to leave the Moto E6s in rice for 24 or 48 hours. The rice will consequently absorb the moisture that stays in the Moto E6s.
Reassemble the components and turn on the Moto E6s
When you have completed the previous steps, your Moto E6s should be dry. So now you can try to turn on the Moto E6s. If this does not do the job, we advise you to hang on a couple of days or to bring the Moto E6s to a repairman.
What should not be done if perhaps the Moto E6s has fallen into the water
You will find a number of stuff not to accomplish when ever your Moto E6s has fallen into the water. The 1st is to try to turn the mobile phone back on just after. This can kill the Moto E6s. Next, it is strongly suggested not to use a heat source to dry the Moto E6s. Without a doubt, techniques which include oven or hair dryer heat the components and may deteriorate them. Finally, to get the water out of the mobile phone, do not shake it. Indeed, it could as well ruin the Moto E6s.
