Whether in the wc or in a pool, it sometimes happens that the CUBOT Max is dropped into the water. On the other hand, it is not because a telephone has fallen into the water that it’s unavoidably dead. In fact, it is possible to redo an CUBOT Max that has fallen into the water. To achieve this, it is needed to respect specific actions. People generally have bad reflexes and this is what can degrade the CUBOT Max. We will 1st see the steps to be taken after the CUBOT Max has fallen into the water. We will see in the 2nd place the classical errors that most people make.
Methods to follow in cases where your CUBOT Max fell into the water
In the event that you want to recover your CUBOT Max in working order, we suggest that you follow the steps listed below.
Do not try to turn the CUBOT Max back on after getting out the water
The first thing to perform when the CUBOT Max has fallen into the water is to turn off the telephone. In fact, in cases where it didn’t turn off, turn it off without doing any other manipulation. In the event that it is already off, do not try to turn it back on for the moment. In the event that the CUBOT Max is turned on and wet, you might produce a short circuit and as a result toast the telephone.
Remove detachable components
Once the CUBOT Max is out of the water and switched off, it will have to be disassembled to the maximum. This implies that it will probably be needed to remove the shell, the SIM card, the SD card and the battery if possible. Once performed, put all of these items to dry and continue to the next step.
Aspire the water that is in your CUBOT Max
Utilizing a straw, you need to suck up the water that is contained in your CUBOT Max. For doing it, you only have to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your CUBOT Max, you will have the capacity to start drying it.
Dry the CUBOT Max
The fourth step is to dry the telephone. For this, we advise you to put it in front of a ventilator several hours. Avoid using méthodes that cause the telephone to heat up or damage the telephone. Once it is performed, we advise you to leave the CUBOT Max in rice for 24 or 48 hours. The rice will as a result absorb the moisture that stays in the CUBOT Max.
Reassemble the components and turn on the CUBOT Max
When you have completed the previous steps, your CUBOT Max should be dry. So now you can make an attempt to turn on the CUBOT Max. If perhaps this does not function, we advise you to hold out a few days or to bring the CUBOT Max to a repairshop.
What should not be done in cases where the CUBOT Max has fallen into the water
You will find several things not to perform when your CUBOT Max has fallen into the water. The 1st is to make an attempt to turn the telephone back on just after. This can destroy the CUBOT Max. Next, it is strongly suggested not to use a heat source to dry the CUBOT Max. Without a doubt, techniques such as oven or hair dryer heat the components and may degrade them. Finally, to get the water out of the telephone, do not shake it. In fact, it could additionally damage the CUBOT Max.
