Whether in the wc or in a pool, it from time to time occurs that the CUBOT Manito is slipped into the water. Nonetheless, it is not because a phone has fallen into the water that it is obviously dead. Certainly, it is feasible to redo an CUBOT Manito that has fallen into the water. To accomplish this, it is required to respect particular actions. People often have bad reflexes and this is what can damage the CUBOT Manito. We will first of all see the methods to be taken after the CUBOT Manito has fallen into the water. We will see in the 2nd place the common errors that many people make.
Methods to follow in cases where your CUBOT Manito fell into the water
In the event that you want to restore your CUBOT Manito in working order, we recommend that you follow the steps listed below.
Do not try to turn the CUBOT Manito back on after getting out the water
The first thing to do when the CUBOT Manito has fallen into the water is to switch off the phone. Certainly, in cases where it did not switch off, turn it off without doing any other tricks. In cases where it is already off, do not try to turn it back on for the moment. In cases where the CUBOT Manito is turned on and wet, you can create a short circuit and therefore toast the phone.
Remove detachable components
When the CUBOT Manito is out of the water and switched off, it will have to be disassembled to the highest possible. This means that it’ll be required to take away the shell, the SIM card, the SD card and the electric battery if possible. When carried out, put all of these things to dry and continue to the following step.
Aspire the water that is in your CUBOT Manito
Utilizing a straw, you need to suck up the water that is contained in your CUBOT Manito. For this, you only have to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your CUBOT Manito, you will have the capacity to start drying it.
Dry the CUBOT Manito
The fourth step is to dry the phone. For this, we suggest you to put it in front of a ventilator several hours. Prevent using procédures that cause the phone to heat up or damage the phone. When it is done, we suggest you to leave the CUBOT Manito in rice for 24 or 48 hours. The rice will therefore absorb the wetness that remains in the CUBOT Manito.
Reassemble the components and turn on the CUBOT Manito
When you have completed the prior steps, your CUBOT Manito should be dry. So now you can try to turn on the CUBOT Manito. If perhaps this does not do the job, we suggest you to hold out a few days or to bring the CUBOT Manito to a repairman.
What should not be done in cases where the CUBOT Manito has fallen into the water
There are several things not to do when your CUBOT Manito has fallen into the water. The first of all is to try to turn the phone back on just after. This can kill the CUBOT Manito. Next, it is highly suggested not to use a heat source to dry the CUBOT Manito. Indeed, solutions such as oven or hair dryer heat the components and may damage them. Finally, to get the water out of the phone, do not shake it. In fact, it could also ruin the CUBOT Manito.
