Whether in the wc or in a pool, it occasionally happens that the Blackview BL6000 is slipped into the water. Nonetheless, it’s not simply because a phone has fallen into the water that it is obviously dead. Indeed, it is feasible to redo an Blackview BL6000 that has fallen into the water. To accomplish this, it is needed to respect certain steps. People typically have bad reflexes and this is what can damage the Blackview BL6000. We will first discover the steps to be taken after the Blackview BL6000 has fallen into the water. We will discover in the 2nd place the common mistakes that a large number of people make.
Steps to follow in cases where your Blackview BL6000 fell into the water
Whenever you wish to restore your Blackview BL6000 in working order, we advise that you follow the steps listed below.
Do not attempt to turn the Blackview BL6000 back on after getting out the water
The first thing to do when the Blackview BL6000 has fallen into the water is to shut off the phone. Indeed, in cases where it did not switch off, turn it off without doing any other manipulation. If it is already off, do not attempt to turn it back on for the moment. If the Blackview BL6000 is switched on and wet, you may create a short circuit and therefore toast the phone.
Remove detachable components
When the Blackview BL6000 is out of the water and switched off, it will have to be disassembled to the highest possible. This means that it’ll be needed to remove the shell, the SIM card, the SD card and the battery if possible. When finished, put all of these items to dry and proceed to the next step.
Aspire the water that is in your Blackview BL6000
By using a straw, you need to suck up the water that is contained in your Blackview BL6000. For this, you just need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Blackview BL6000, you will have the ability to start drying it.
Dry the Blackview BL6000
The fourth step is to dry the phone. For this, we recommend you to put it in front of a ventilator several hours. Avoid using procédures that cause the phone to heat up or damage the phone. When it is finished, we recommend you to leave the Blackview BL6000 in rice for 24 or 48 hours. The rice will therefore absorb the wetness that stays in the Blackview BL6000.
Reassemble the components and turn on the Blackview BL6000
When you have completed the previous steps, your Blackview BL6000 should be dry. So now you can make an attempt to turn on the Blackview BL6000. If perhaps this does not perform, we recommend you to hold out a few days or to bring the Blackview BL6000 to a repairshop.
What should not be done in cases where the Blackview BL6000 has fallen into the water
There are several things not to do when ever your Blackview BL6000 has fallen into the water. The first is to make an attempt to turn the phone back on just after. This can destroy the Blackview BL6000. Next, it is strongly suggested not to use a heat source to dry the Blackview BL6000. Certainly, methods which include oven or hair dryer heat the components and may damage them. Finally, to get the water out of the phone, do not shake it. Certainly, it could also damage the Blackview BL6000.
