Whether in the toilet or in a pool, it occasionally happens that the CUBOT ECHO is dropped into the water. Even so, it is not because a mobile has fallen into the water that it’s obviously dead. In truth, it is feasible to redo an CUBOT ECHO that has fallen into the water. To get this done, it is required to respect specific steps. People generally have bad reflexes and this is what can deteriorate the CUBOT ECHO. We will 1st see the methods to be taken after the CUBOT ECHO has fallen into the water. We will see in the secondary place the classical errors that many people make.
Methods to follow if your CUBOT ECHO fell into the water
Whenever you need to recover your CUBOT ECHO in working order, we suggest that you follow the steps below.
Don’t attempt to turn the CUBOT ECHO back on after getting out the water
The very first thing to accomplish when the CUBOT ECHO has fallen into the water is to turn off the mobile. In truth, if it didn’t switch off, turn it off without doing any other manipulation. In the event that it is already off, do not attempt to turn it back on for the moment. In the event that the CUBOT ECHO is switched on and wet, you may produce a short circuit and therefore toast the mobile.
Remove detachable components
Once the CUBOT ECHO is out of the water and turned off, it will have to be disassembled to the maximum. This means that it will probably be required to take out the shell, the SIM card, the SD card and the electric battery if possible. Once performed, put all of these items to dry and proceed to the following step.
Aspire the water that is in your CUBOT ECHO
Using a straw, you need to suck up the water that is contained in your CUBOT ECHO. For this, you simply need to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your CUBOT ECHO, you will be ready to start drying it.
Dry the CUBOT ECHO
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using methods that cause the mobile to heat up or damage the mobile. Once it is completed, we advise you to leave the CUBOT ECHO in rice for 24 or 48 hours. The rice will therefore absorb the moisture that stays in the CUBOT ECHO.
Reassemble the components and turn on the CUBOT ECHO
When you have completed the previous steps, your CUBOT ECHO should be dry. So now you can try to turn on the CUBOT ECHO. In the event that this does not perform, we advise you to hang on a few days or to bring the CUBOT ECHO to a repairman.
What should not be done if the CUBOT ECHO has fallen into the water
There are a number of points not to accomplish when ever your CUBOT ECHO has fallen into the water. The 1st is to try to turn the mobile back on just after. This can destroy the CUBOT ECHO. Following, it is highly recommended not to use a heat source to dry the CUBOT ECHO. In fact, methods which include oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the mobile, do not shake it. Indeed, it could additionally damage the CUBOT ECHO.
