Whether in the wc or in a swimming pool, it sometimes occurs that the Tecno Spark Power is slipped into the water. Nevertheless, it isn’t because a mobile has fallen into the water that it is undoubtedly dead. In fact, it is possible to redo an Tecno Spark Power that has fallen into the water. To do this, it is required to respect particular actions. People frequently have bad reflexes and this is what can damage the Tecno Spark Power. We will first see the techniques to be taken after the Tecno Spark Power has fallen into the water. We will see in the second place the common mistakes that a good number of people make.
Methods to follow if perhaps your Tecno Spark Power fell into the water
If you desire to restore your Tecno Spark Power in operating order, we highly recommend that you follow the steps listed below.
Don’t attempt to turn the Tecno Spark Power back on after exiting the water
The first thing to accomplish when the Tecno Spark Power has fallen into the water is to shut off the mobile. In fact, if perhaps it didn’t switch off, turn it off without doing any other tricks. If it is already off, do not attempt to turn it back on for the moment. If the Tecno Spark Power is started and wet, you might generate a short circuit and as a result toast the mobile.
Remove detachable components
Once the Tecno Spark Power is out of the water and switched off, it will have to be disassembled to the maximum. This implies that it will probably be required to remove the shell, the SIM card, the SD card and the battery if possible. Once done, put all of these items to dry and continue to the following step.
Aspire the water that is in your Tecno Spark Power
By using a straw, you must suck up the water that is contained in your Tecno Spark Power. For this, you simply have to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your Tecno Spark Power, you will be ready to start drying it.
Dry the Tecno Spark Power
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using procédures that cause the mobile to heat up or damage the mobile. Once it is performed, we advise you to leave the Tecno Spark Power in rice for 24 or 48 hours. The rice will as a result absorb the moisture that remains in the Tecno Spark Power.
Reassemble the components and turn on the Tecno Spark Power
When you have completed the prior steps, your Tecno Spark Power should be dry. So now you can try to turn on the Tecno Spark Power. In the event that this doesn’t function, we advise you to wait a couple of days or to bring the Tecno Spark Power to a repairshop.
What should not be done if perhaps the Tecno Spark Power has fallen into the water
There are a number of points not to accomplish when your Tecno Spark Power has fallen into the water. The first is to try to turn the mobile back on just after. This can kill the Tecno Spark Power. Next, it is strongly recommended not to use a heat source to dry the Tecno Spark Power. In fact, techniques such as oven or hair dryer heat the components and may damage them. At last, to get the water out of the mobile, do not shake it. Indeed, it could as well ruin the Tecno Spark Power.
