Whether in the wc or in a swimming pool, it sometimes occurs that the Poco X2 is slipped in the water. Nonetheless, it isn’t simply because a mobile phone has fallen in the water that it’s obviously dead. In fact, it is feasible to redo an Poco X2 that has fallen in the water. To get this done, it is essential to respect certain steps. People typically have bad reflexes and this is what can deteriorate the Poco X2. We will first of all discover the methods to be taken after the Poco X2 has fallen into the water. We will discover in the secondary place the classical mistakes that most people make.
Steps to follow in cases where your Poco X2 fell into the water
If perhaps you desire to recover your Poco X2 in operating order, we suggest that you follow the steps listed below.
Do not try to turn the Poco X2 back on after getting out the water
The first thing to do when the Poco X2 has fallen into the water is to switch off the mobile phone. In fact, in cases where it did not turn off, turn it off without doing any other tricks. If it is already off, do not try to turn it back on for the moment. If the Poco X2 is switched on and wet, you could create a short circuit and consequently toast the mobile phone.
Remove detachable components
Once the Poco X2 is out of the water and turned off, it will have to be disassembled to the maximum. Meaning that it’ll be essential to remove the shell, the SIM card, the SD card and the electric battery if possible. Once carried out, put all of these items to dry and proceed to the following step.
Aspire the water that is in your Poco X2
By using a straw, you will have to suck up the water that is contained in your Poco X2. For this, you just need to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your Poco X2, you will have the capacity to start drying it.
Dry the Poco X2
The fourth step is to dry the mobile phone. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using procédures that cause the mobile phone to heat up or damage the mobile phone. Once it is finished, we advise you to leave the Poco X2 in rice for 24 or 48 hours. The rice will consequently absorb the wetness that stays in the Poco X2.
Reassemble the components and turn on the Poco X2
When you have completed the prior steps, your Poco X2 should be dry. So now you can try to turn on the Poco X2. If this does not perform, we advise you to wait some days or to bring the Poco X2 to a repairshop.
What should not be done in cases where the Poco X2 has fallen into the water
There are a number of things not to do when ever your Poco X2 has fallen into the water. The first of all is to try to turn the mobile phone back on just after. This can destroy the Poco X2. Next, it is strongly recommended not to use a heat source to dry the Poco X2. In fact, methods such as oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the mobile phone, do not shake it. In fact, it could additionally damage the Poco X2.