Whether in the wc or in a swimming pool, it sometimes occurs that the Motorola Razr i is slipped into the water. Even so, it’s not because a cellphone has fallen into the water that it is unavoidably dead. Indeed, it is feasible to redo an Motorola Razr i that has fallen into the water. To achieve this, it is needed to respect certain steps. People typically have bad reflexes and this is what can damage the Motorola Razr i. We will 1st see the steps to be taken after the Motorola Razr i has fallen into the water. We will see in the 2nd place the common errors that most people make.
Methods to follow if perhaps your Motorola Razr i fell into the water
In the event that you need to recover your Motorola Razr i in working order, we advise that you follow the steps below.
Do not attempt to turn the Motorola Razr i back on after exiting the water
The very first thing to do when the Motorola Razr i has fallen into the water is to switch off the cellphone. Indeed, if perhaps it didn’t switch off, turn it off without doing any other manipulation. In the event that it is already off, do not attempt to turn it back on for the moment. In the event that the Motorola Razr i is started and wet, you may produce a short circuit and consequently toast the cellphone.
Remove detachable components
Once the Motorola Razr i is out of the water and switched off, it will have to be disassembled to the maximum. This implies that it will be needed to take away the shell, the SIM card, the SD card and the battery if possible. Once completed, put all of these items to dry and continue to the following step.
Aspire the water that is in your Motorola Razr i
Employing a straw, you need to suck up the water that is contained in your Motorola Razr i. For this, you merely need to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Motorola Razr i, you will be ready to start drying it.
Dry the Motorola Razr i
The fourth step is to dry the cellphone. For this, we suggest you to put it in front of a ventilator a number of hours. Avoid using methods that cause the cellphone to heat up or damage the cellphone. Once it is performed, we suggest you to leave the Motorola Razr i in rice for 24 or 48 hours. The rice will consequently absorb the moisture that stays in the Motorola Razr i.
Reassemble the components and turn on the Motorola Razr i
When you have completed the previous steps, your Motorola Razr i should be dry. So now you can try to turn on the Motorola Razr i. In the event that this doesn’t perform, we suggest you to hold out a few days or to bring the Motorola Razr i to a repairman.
What should not be done if perhaps the Motorola Razr i has fallen into the water
There are a number of things not to do when your Motorola Razr i has fallen into the water. The 1st is to try to turn the cellphone back on just after. This can demolish the Motorola Razr i. Following, it is strongly recommended not to use a heat source to dry the Motorola Razr i. Without a doubt, methods such as oven or hair dryer heat the components and may damage them. At last, to get the water out of the cellphone, do not shake it. Certainly, it could also damage the Motorola Razr i.
