Whether in the toilet or in a pool, it from time to time occurs that the Blackview A90 is dropped in the water. On the other hand, it’s not simply because a mobile has fallen in the water that it’s unavoidably dead. Indeed, it is feasible to redo an Blackview A90 that has fallen in the water. To achieve this, it is necessary to respect particular actions. People frequently have bad reflexes and this is what can deteriorate the Blackview A90. We will 1st see the steps to be taken after the Blackview A90 has fallen into the water. We will see in the 2nd place the common mistakes that a large number of people make.
Steps to follow in cases where your Blackview A90 fell into the water
If perhaps you need to restore your Blackview A90 in operating order, we highly recommend that you follow the steps below.
Do not try to turn the Blackview A90 back on after getting out the water
The very first thing to perform when the Blackview A90 has fallen into the water is to switch off the mobile. Indeed, in cases where it didn’t switch off, turn it off without doing any other tricks. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Blackview A90 is turned on and wet, you may produce a short circuit and as a result toast the mobile.
Remove detachable components
Once the Blackview A90 is out of the water and turned off, it will have to be disassembled to the maximum. This implies that it will probably be necessary to take out the shell, the SIM card, the SD card and the electric battery if possible. Once performed, put all of these items to dry and continue to the following step.
Aspire the water that is in your Blackview A90
Using a straw, you will need to suck up the water that is contained in your Blackview A90. For doing it, you merely have to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your Blackview A90, you will be able to start drying it.
Dry the Blackview A90
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using techniques that cause the mobile to heat up or damage the mobile. Once it is completed, we advise you to leave the Blackview A90 in rice for 24 or 48 hours. The rice will as a result absorb the moisture that stays in the Blackview A90.
Reassemble the components and turn on the Blackview A90
When you have completed the prior steps, your Blackview A90 should be dry. So now you can try to turn on the Blackview A90. If perhaps this doesn’t perform, we advise you to hold out a few days or to bring the Blackview A90 to a repairman.
What should not be done in cases where the Blackview A90 has fallen into the water
You will find a number of points not to perform when your Blackview A90 has fallen into the water. The 1st is to try to turn the mobile back on just after. This can kill the Blackview A90. Following, it is strongly suggested not to use a heat source to dry the Blackview A90. Indeed, solutions such as oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the mobile, do not shake it. In fact, it could additionally ruin the Blackview A90.
