Whether in the wc or in a pool, it sometimes happens that the Blackview A100 is dropped in the water. However, it’s not because a telephone has fallen in the water that it is unavoidably dead. Certainly, it is feasible to redo an Blackview A100 that has fallen in the water. To accomplish this, it is important to respect particular actions. People typically have bad reflexes and this is what can degrade the Blackview A100. We will 1st see the techniques to be taken after the Blackview A100 has fallen into the water. We will see in the second place the common mistakes that the majority of people make.
Steps to follow if perhaps your Blackview A100 fell into the water
If you need to recover your Blackview A100 in operating order, we highly recommend that you follow the steps listed below.
Do not try to turn the Blackview A100 back on after getting out the water
One thing to do when the Blackview A100 has fallen into the water is to shut off the telephone. Certainly, if perhaps it did not switch off, turn it off without doing any other tricks. In the event that it is already off, do not try to turn it back on for the moment. In the event that the Blackview A100 is switched on and wet, you might generate a short circuit and consequently toast the telephone.
Remove detachable components
Once the Blackview A100 is out of the water and switched off, it will have to be disassembled to the maximum. This means that it will be important to take away the shell, the SIM card, the SD card and the battery if possible. Once done, put all of these things to dry and proceed to the next step.
Aspire the water that is in your Blackview A100
Using a straw, you need to suck up the water that is contained in your Blackview A100. For doing it, you only have to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your Blackview A100, you will be ready to start drying it.
Dry the Blackview A100
The fourth step is to dry the telephone. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using methods that cause the telephone to heat up or damage the telephone. Once it is done, we advise you to leave the Blackview A100 in rice for 24 or 48 hours. The rice will consequently absorb the moisture that remains in the Blackview A100.
Reassemble the components and turn on the Blackview A100
When you have completed the previous steps, your Blackview A100 should be dry. So now you can make an attempt to turn on the Blackview A100. If this does not function, we advise you to hang on a couple of days or to bring the Blackview A100 to a repairman.
What should not be done if perhaps the Blackview A100 has fallen into the water
You will find a number of stuff not to do when your Blackview A100 has fallen into the water. The 1st is to make an attempt to turn the telephone back on just after. This can kill the Blackview A100. Following, it is strongly advised not to use a heat source to dry the Blackview A100. In fact, solutions which include oven or hair dryer heat the components and may degrade them. At last, to get the water out of the telephone, do not shake it. Certainly, it could also damage the Blackview A100.
