Opening the Wiko ROBBY and removing its hull could be an extremely useful procedure in several situations. If you would like to insert a SIM card or an SD memory card, you might need to remove the cover and open the Wiko ROBBY. Opening the Wiko ROBBY is also important when you want to remove the battery or when you desire to dust off the inside of your phone. We will first of all see ways to find the point that allows to open the hull of Wiko ROBBY. We will see in a second section the method to open the hull of Wiko ROBBY.
Finding the opening point of Wiko ROBBY
If you would like to open your Wiko ROBBY, the first of all step is to find the opening point of the hull. To get this done, we recommend you to refer to the operating instructions of your Wiko ROBBY. In the event you do not have the user manual of your Wiko ROBBY, you can actually locate it on the internet. Most of the time, the technique of removing the hull is to slide the hull or to unclip it. However, we recommend you to be vigilant when doing this step, in order not to damage your Wiko ROBBY. Once you have found the opening point of the hull, you will finally be able to open your Wiko ROBBY.
Open the Wiko ROBBY
When you know where the Wiko ROBBY opening point is, you will have the ability to start opening the back part of the hull. To get this done slide or boot the rear part of the shell in accordance to the model of your Wiko ROBBY. When it truly is done, half of the hull is removed. This should permit you to access the battery and perhaps the SIM card of your Wiko ROBBY. If you would like to remove the front part of the hull of the mobile phone, know that it truly is a tad bit more complex. For this, we recommend you to go in retail store or in specific shop.
The precautions to be taken when opening the Wiko ROBBY
You should know that the hull of the Wiko ROBBY protects the sensitive components that are inside the telephone. So, in the event you decide to open the Wiko ROBBY, you will need to handle the mobile phone cautiously. In fact, the elements just like the battery, the printed circuit boards or the SIM card are sensitive. Do not allow dust or moisture to get inside the telephone. Install in a clean environment to do this.
