Whether in the wc or in a pool, it sometimes occurs that the Wiko Slide is dropped into the water. Nonetheless, it is not simply because a mobile phone has fallen into the water that it is unavoidably dead. In fact, it is possible to redo an Wiko Slide that has fallen into the water. To accomplish this, it is important to respect particular steps. People frequently have bad reflexes and this is what can degrade the Wiko Slide. We will 1st discover the techniques to be taken after the Wiko Slide has fallen into the water. We will discover in the 2nd place the common errors that many people make.
Methods to follow in the event that your Wiko Slide fell into the water
Whenever you need to restore your Wiko Slide in operating order, we recommend that you follow the steps below.
Don’t try to turn the Wiko Slide back on after exiting the water
One thing to perform when the Wiko Slide has fallen into the water is to shut off the mobile phone. In fact, in the event that it did not turn off, turn it off without doing any other tricks. If it is already off, do not try to turn it back on for the moment. If the Wiko Slide is turned on and wet, you may make a short circuit and as a result toast the mobile phone.
Remove detachable components
Once the Wiko Slide is out of the water and switched off, it will have to be disassembled to the maximum. This means that it’ll be important to take out the shell, the SIM card, the SD card and the battery if possible. Once finished, put all of these things to dry and proceed to the following step.
Aspire the water that is in your Wiko Slide
Utilizing a straw, you need to suck up the water that is contained in your Wiko Slide. For doing it, you merely have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Wiko Slide, you will be ready to start drying it.
Dry the Wiko Slide
The fourth step is to dry the mobile phone. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using methods that cause the mobile phone to heat up or damage the mobile phone. Once it is completed, we advise you to leave the Wiko Slide in rice for 24 or 48 hours. The rice will as a result absorb the wetness that stays in the Wiko Slide.
Reassemble the components and turn on the Wiko Slide
When you have completed the previous steps, your Wiko Slide should be dry. So now you can try to turn on the Wiko Slide. If this does not work, we advise you to wait a few days or to bring the Wiko Slide to a repairshop.
What should not be done in the event that the Wiko Slide has fallen into the water
You will find a number of points not to perform when your Wiko Slide has fallen into the water. The 1st is to try to turn the mobile phone back on just after. This can demolish the Wiko Slide. Next, it is highly recommended not to use a heat source to dry the Wiko Slide. Indeed, methods which include oven or hair dryer heat the components and may degrade them. Finally, to get the water out of the mobile phone, do not shake it. In fact, it could additionally damage the Wiko Slide.
