Whether in the toilet or in a swimming pool, it sometimes happens that the Wiko Kite is dropped into the water. On the other hand, it isn’t because a mobile has fallen into the water that it’s undoubtedly dead. Certainly, it is feasible to redo an Wiko Kite that has fallen into the water. To do this, it is required to respect specific actions. People typically have bad reflexes and this is what can degrade the Wiko Kite. We will 1st see the methods to be taken after the Wiko Kite has fallen into the water. We will see in the 2nd place the classical errors that a good number of people make.
Steps to follow in cases where your Wiko Kite fell into the water
Whenever you need to recover your Wiko Kite in working order, we recommend that you follow the steps listed below.
Do not try to turn the Wiko Kite back on after exiting the water
The very first thing to do when the Wiko Kite has fallen into the water is to turn off the mobile. Certainly, in cases where it did not turn off, turn it off without doing any other tricks. In cases where it is already off, do not try to turn it back on for the moment. In cases where the Wiko Kite is turned on and wet, you might make a short circuit and as a result toast the mobile.
Remove detachable components
When the Wiko Kite is out of the water and switched off, it will have to be disassembled to the maximum. This means that it will probably be required to take out the shell, the SIM card, the SD card and the battery if possible. When completed, put all of these things to dry and proceed to the following step.
Aspire the water that is in your Wiko Kite
Using a straw, you have got to suck up the water that is contained in your Wiko Kite. For doing it, you merely need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Wiko Kite, you will be ready to start drying it.
Dry the Wiko Kite
The fourth step is to dry the mobile. For this, we recommend you to put it in front of a ventilator a number of hours. Prevent using methods that cause the mobile to heat up or damage the mobile. When it is completed, we recommend you to leave the Wiko Kite in rice for 24 or 48 hours. The rice will as a result absorb the wetness that stays in the Wiko Kite.
Reassemble the components and turn on the Wiko Kite
When you have completed the previous steps, your Wiko Kite should be dry. So now you can try to turn on the Wiko Kite. If perhaps this doesn’t do the job, we recommend you to hold out a couple of days or to bring the Wiko Kite to a repairshop.
What should not be done in cases where the Wiko Kite has fallen into the water
You will find a number of points not to do when your Wiko Kite has fallen into the water. The 1st is to try to turn the mobile back on just after. This can kill the Wiko Kite. Next, it is strongly recommended not to use a heat source to dry the Wiko Kite. Without a doubt, solutions which include oven or hair dryer heat the components and may degrade them. Finally, to get the water out of the mobile, do not shake it. In fact, it could additionally ruin the Wiko Kite.
