How to fix a water damaged on Vibe A7010

Whether in the wc or in a swimming pool, it sometimes happens that the Vibe A7010 is slipped in the water. Even so, it is not because a mobile has fallen in the water that it is inevitably dead. In truth, it is feasible to redo an Vibe A7010 that has fallen in the water. To do this, it is essential to respect specific actions. People generally have bad reflexes and this is what can degrade the Vibe A7010. We will first see the steps to be taken after the Vibe A7010 has fallen into the water. We will see in the 2nd place the common mistakes that most people make.water-damaged-Vibe-A7010

Steps to follow in cases where your Vibe A7010 fell into the water

Whenever you desire to recover your Vibe A7010 in operating order, we highly recommend that you follow the steps listed below.

Do not attempt to turn the Vibe A7010 back on after getting out the water

One thing to perform when the Vibe A7010 has fallen into the water is to shut off the mobile. In truth, in cases where it didn’t turn off, turn it off without doing any other manipulation. In the event that it is already off, do not attempt to turn it back on for the moment. In the event that the Vibe A7010 is switched on and wet, you might create a short circuit and as a result toast the mobile.

Remove detachable components

Once the Vibe A7010 is out of the water and turned off, it will have to be disassembled to the maximum. This implies that it will probably be essential to remove the shell, the SIM card, the SD card and the battery if possible. Once done, put all of these things to dry and proceed to the next step.

Aspire the water that is in your Vibe A7010

Utilizing a straw, you must suck up the water that is contained in your Vibe A7010. For doing it, you merely have to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your Vibe A7010, you will have the ability to start drying it.

Dry the Vibe A7010

The fourth step is to dry the mobile. For this, we recommend you to put it in front of a ventilator several hours. Prevent using solutions that cause the mobile to heat up or damage the mobile. Once it is performed, we recommend you to leave the Vibe A7010 in rice for 24 or 48 hours. The rice will as a result absorb the moisture that stays in the Vibe A7010.

Reassemble the components and turn on the Vibe A7010

When you have completed the prior steps, your Vibe A7010 should be dry. So now you can try to turn on the Vibe A7010. If perhaps this doesn’t do the job, we recommend you to hang on some days or to bring the Vibe A7010 to a repairshop.

What should not be done in cases where the Vibe A7010 has fallen into the water

There are several points not to perform when ever your Vibe A7010 has fallen into the water. The first is to try to turn the mobile back on just after. This can kill the Vibe A7010. Next, it is strongly suggested not to use a heat source to dry the Vibe A7010. Certainly, solutions such as oven or hair dryer heat the components and may degrade them. Finally, to get the water out of the mobile, do not shake it. In fact, it could also ruin the Vibe A7010.