Whether in the toilet or in a pool, it from time to time occurs that the Tecno Spark 4 is dropped in the water. However, it isn’t simply because a mobile phone has fallen in the water that it is undoubtedly dead. In fact, it is possible to redo an Tecno Spark 4 that has fallen in the water. To do this, it is required to respect particular steps. People typically have bad reflexes and this is what can damage the Tecno Spark 4. We will first discover the steps to be taken after the Tecno Spark 4 has fallen into the water. We will discover in the second place the classical errors that a good number of people make.
Steps to follow in cases where your Tecno Spark 4 fell into the water
In the event that you want to restore your Tecno Spark 4 in operating order, we suggest that you follow the steps below.
Do not try to turn the Tecno Spark 4 back on after exiting the water
The very first thing to do when the Tecno Spark 4 has fallen into the water is to turn off the mobile phone. In fact, in cases where it did not switch off, turn it off without doing any other tricks. If it is already off, do not try to turn it back on for the moment. If the Tecno Spark 4 is switched on and wet, you may make a short circuit and therefore toast the mobile phone.
Remove detachable components
Once the Tecno Spark 4 is out of the water and switched off, it will have to be disassembled to the maximum. This means that it will probably be required to take out the shell, the SIM card, the SD card and the electric battery if possible. Once carried out, put all of these items to dry and continue to the next step.
Aspire the water that is in your Tecno Spark 4
Employing a straw, you must suck up the water that is contained in your Tecno Spark 4. For this, you only have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Tecno Spark 4, you will be ready to start drying it.
Dry the Tecno Spark 4
The fourth step is to dry the mobile phone. For this, we suggest you to put it in front of a ventilator several hours. Prevent using méthodes that cause the mobile phone to heat up or damage the mobile phone. Once it is finished, we suggest you to leave the Tecno Spark 4 in rice for 24 or 48 hours. The rice will therefore absorb the moisture that stays in the Tecno Spark 4.
Reassemble the components and turn on the Tecno Spark 4
When you have completed the prior steps, your Tecno Spark 4 should be dry. So now you can make an attempt to turn on the Tecno Spark 4. If perhaps this doesn’t function, we suggest you to hang on a couple of days or to bring the Tecno Spark 4 to a repairshop.
What should not be done in cases where the Tecno Spark 4 has fallen into the water
There are several points not to do when your Tecno Spark 4 has fallen into the water. The first is to make an attempt to turn the mobile phone back on just after. This can kill the Tecno Spark 4. Next, it is strongly recommended not to use a heat source to dry the Tecno Spark 4. Without a doubt, techniques which include oven or hair dryer heat the components and may damage them. Finally, to get the water out of the mobile phone, do not shake it. Certainly, it could also damage the Tecno Spark 4.
