Whether in the wc or in a swimming pool, it sometimes happens that the Quantum GO is slipped into the water. On the other hand, it isn’t simply because a mobile has fallen into the water that it’s unavoidably dead. In fact, it is feasible to redo an Quantum GO that has fallen into the water. To do this, it is essential to respect specific steps. People generally have bad reflexes and this is what can deteriorate the Quantum GO. We will 1st discover the steps to be taken after the Quantum GO has fallen into the water. We will discover in the secondary place the classical mistakes that a large number of people make.
Methods to follow in cases where your Quantum GO fell into the water
If you wish to restore your Quantum GO in working order, we suggest that you follow the steps listed below.
Don’t try to turn the Quantum GO back on after getting out the water
The very first thing to perform when the Quantum GO has fallen into the water is to turn off the mobile. In fact, in cases where it did not switch off, turn it off without doing any other manipulation. In cases where it is already off, do not try to turn it back on for the moment. In cases where the Quantum GO is switched on and wet, you can produce a short circuit and consequently toast the mobile.
Remove detachable components
Once the Quantum GO is out of the water and turned off, it will have to be disassembled to the highest possible. This means that it will probably be essential to take out the shell, the SIM card, the SD card and the battery if possible. Once done, put all of these things to dry and continue to the following step.
Aspire the water that is in your Quantum GO
Utilizing a straw, you will need to suck up the water that is contained in your Quantum GO. For doing it, you only need to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Quantum GO, you will be able to start drying it.
Dry the Quantum GO
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator several hours. Avoid using solutions that cause the mobile to heat up or damage the mobile. Once it is completed, we advise you to leave the Quantum GO in rice for 24 or 48 hours. The rice will consequently absorb the moisture that stays in the Quantum GO.
Reassemble the components and turn on the Quantum GO
When you have completed the previous steps, your Quantum GO should be dry. So now you can try to turn on the Quantum GO. If this does not perform, we advise you to hang on some days or to bring the Quantum GO to a repairman.
What should not be done in cases where the Quantum GO has fallen into the water
You will find several points not to perform when ever your Quantum GO has fallen into the water. The 1st is to try to turn the mobile back on just after. This can kill the Quantum GO. Next, it is highly suggested not to use a heat source to dry the Quantum GO. Without a doubt, solutions which include oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the mobile, do not shake it. Indeed, it could likewise damage the Quantum GO.
