Whether in the toilet or in a pool, it sometimes occurs that the Motorola edge 20 is slipped in the water. However, it isn’t because a phone has fallen in the water that it’s unavoidably dead. Indeed, it is feasible to redo an Motorola edge 20 that has fallen in the water. To accomplish this, it is needed to respect certain steps. People generally have bad reflexes and this is what can damage the Motorola edge 20. We will 1st see the methods to be taken after the Motorola edge 20 has fallen into the water. We will see in the 2nd place the common errors that most people make.
Methods to follow if your Motorola edge 20 fell into the water
Whenever you desire to restore your Motorola edge 20 in operating order, we advise that you follow the steps listed below.
Don’t attempt to turn the Motorola edge 20 back on after getting out the water
The first thing to perform when the Motorola edge 20 has fallen into the water is to switch off the phone. Indeed, if it didn’t switch off, turn it off without doing any other tricks. If it is already off, do not attempt to turn it back on for the moment. If the Motorola edge 20 is turned on and wet, you may make a short circuit and therefore toast the phone.
Remove detachable components
When the Motorola edge 20 is out of the water and switched off, it will have to be disassembled to the highest possible. This implies that it will probably be needed to remove the shell, the SIM card, the SD card and the electric battery if possible. When carried out, put all of these items to dry and proceed to the next step.
Aspire the water that is in your Motorola edge 20
Utilizing a straw, you will have to suck up the water that is contained in your Motorola edge 20. For doing it, you just need to glue the straw over areas like buttons and vacuum. When you think you have aspired all the water from your Motorola edge 20, you will be able to start drying it.
Dry the Motorola edge 20
The fourth step is to dry the phone. For this, we recommend you to put it in front of a ventilator a number of hours. Avoid using procédures that cause the phone to heat up or damage the phone. When it is performed, we recommend you to leave the Motorola edge 20 in rice for 24 or 48 hours. The rice will therefore absorb the moisture that remains in the Motorola edge 20.
Reassemble the components and turn on the Motorola edge 20
When you have completed the previous steps, your Motorola edge 20 should be dry. So now you can try to turn on the Motorola edge 20. If perhaps this doesn’t function, we recommend you to hang on a couple of days or to bring the Motorola edge 20 to a repairman.
What should not be done if the Motorola edge 20 has fallen into the water
There are a number of things not to perform when your Motorola edge 20 has fallen into the water. The 1st is to try to turn the phone back on just after. This can destroy the Motorola edge 20. Next, it is strongly recommended not to use a heat source to dry the Motorola edge 20. Certainly, solutions which include oven or hair dryer heat the components and may damage them. At last, to get the water out of the phone, do not shake it. In fact, it could as well damage the Motorola edge 20.
