Whether in the wc or in a swimming pool, it from time to time occurs that the Lava A1200 is slipped into the water. Nevertheless, it’s not simply because a mobile has fallen into the water that it’s undoubtedly dead. In truth, it is possible to redo an Lava A1200 that has fallen into the water. To get this done, it is needed to respect particular actions. People typically have bad reflexes and this is what can degrade the Lava A1200. We will first of all discover the steps to be taken after the Lava A1200 has fallen into the water. We will discover in the 2nd place the classical mistakes that a large number of people make.
Steps to follow in cases where your Lava A1200 fell into the water
If you want to restore your Lava A1200 in operating order, we recommend that you follow the steps listed below.
Don’t try to turn the Lava A1200 back on after exiting the water
The first thing to do when the Lava A1200 has fallen into the water is to turn off the mobile. In truth, in cases where it didn’t switch off, turn it off without doing any other tricks. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Lava A1200 is started and wet, you may produce a short circuit and therefore toast the mobile.
Remove detachable components
When the Lava A1200 is out of the water and switched off, it will have to be disassembled to the highest possible. This means that it will probably be needed to take away the shell, the SIM card, the SD card and the battery if possible. When finished, put all of these items to dry and proceed to the next step.
Aspire the water that is in your Lava A1200
Employing a straw, you will have to suck up the water that is contained in your Lava A1200. For doing it, you only need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Lava A1200, you will be ready to start drying it.
Dry the Lava A1200
The fourth step is to dry the mobile. For this, we recommend you to put it in front of a ventilator several hours. Prevent using techniques that cause the mobile to heat up or damage the mobile. When it is performed, we recommend you to leave the Lava A1200 in rice for 24 or 48 hours. The rice will therefore absorb the moisture that stays in the Lava A1200.
Reassemble the components and turn on the Lava A1200
When you have completed the prior steps, your Lava A1200 should be dry. So now you can make an attempt to turn on the Lava A1200. In the event that this doesn’t perform, we recommend you to hang on a few days or to bring the Lava A1200 to a repairshop.
What should not be done in cases where the Lava A1200 has fallen into the water
You will find several things not to do when ever your Lava A1200 has fallen into the water. The first of all is to make an attempt to turn the mobile back on just after. This can destroy the Lava A1200. Next, it is highly advised not to use a heat source to dry the Lava A1200. Without a doubt, techniques such as oven or hair dryer heat the components and may degrade them. At last, to get the water out of the mobile, do not shake it. Certainly, it could as well ruin the Lava A1200.
