Whether in the wc or in a swimming pool, it from time to time happens that the CUBE1 G503 is dropped into the water. On the other hand, it’s not simply because a phone has fallen into the water that it is undoubtedly dead. Indeed, it is feasible to redo an CUBE1 G503 that has fallen into the water. To get this done, it is needed to respect particular steps. People often have bad reflexes and this is what can deteriorate the CUBE1 G503. We will first of all see the techniques to be taken after the CUBE1 G503 has fallen into the water. We will see in the 2nd place the common errors that a good number of people make.
Steps to follow if perhaps your CUBE1 G503 fell into the water
If perhaps you want to restore your CUBE1 G503 in operating order, we highly recommend that you follow the steps below.
Do not try to turn the CUBE1 G503 back on after exiting the water
The very first thing to accomplish when the CUBE1 G503 has fallen into the water is to turn off the phone. Indeed, if perhaps it didn’t turn off, turn it off without doing any other manipulation. In the event that it is already off, do not try to turn it back on for the moment. In the event that the CUBE1 G503 is started and wet, you may create a short circuit and therefore toast the phone.
Remove detachable components
When the CUBE1 G503 is out of the water and switched off, it will have to be disassembled to the maximum. Meaning that it will probably be needed to remove the shell, the SIM card, the SD card and the battery if possible. When carried out, put all of these items to dry and proceed to the following step.
Aspire the water that is in your CUBE1 G503
Employing a straw, you will need to suck up the water that is contained in your CUBE1 G503. For this, you only have to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your CUBE1 G503, you will have the capacity to start drying it.
Dry the CUBE1 G503
The fourth step is to dry the phone. For this, we suggest you to put it in front of a ventilator a number of hours. Prevent using procédures that cause the phone to heat up or damage the phone. When it is finished, we suggest you to leave the CUBE1 G503 in rice for 24 or 48 hours. The rice will therefore absorb the moisture that stays in the CUBE1 G503.
Reassemble the components and turn on the CUBE1 G503
When you have completed the previous steps, your CUBE1 G503 should be dry. So now you can make an attempt to turn on the CUBE1 G503. If this does not work, we suggest you to hold out some days or to bring the CUBE1 G503 to a repairman.
What should not be done if perhaps the CUBE1 G503 has fallen into the water
There are a number of points not to accomplish when your CUBE1 G503 has fallen into the water. The first of all is to make an attempt to turn the phone back on just after. This can destroy the CUBE1 G503. Next, it is strongly suggested not to use a heat source to dry the CUBE1 G503. In fact, methods which include oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the phone, do not shake it. In fact, it could also ruin the CUBE1 G503.
