Whether in the wc or in a pool, it occasionally happens that the Crosscall Trekker-X4 is dropped into the water. Nevertheless, it’s not because a phone has fallen into the water that it’s inevitably dead. In fact, it is possible to redo an Crosscall Trekker-X4 that has fallen into the water. To accomplish this, it is essential to respect particular actions. People generally have bad reflexes and this is what can deteriorate the Crosscall Trekker-X4. We will 1st see the techniques to be taken after the Crosscall Trekker-X4 has fallen into the water. We will see in the secondary place the common mistakes that the majority of people make.
Steps to follow if your Crosscall Trekker-X4 fell into the water
If perhaps you wish to restore your Crosscall Trekker-X4 in operating order, we recommend that you follow the steps listed below.
Do not try to turn the Crosscall Trekker-X4 back on after exiting the water
One thing to accomplish when the Crosscall Trekker-X4 has fallen into the water is to shut off the phone. In fact, if it didn’t turn off, turn it off without doing any other manipulation. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Crosscall Trekker-X4 is turned on and wet, you may make a short circuit and consequently toast the phone.
Remove detachable components
When the Crosscall Trekker-X4 is out of the water and switched off, it will have to be disassembled to the maximum. This means that it will probably be essential to remove the shell, the SIM card, the SD card and the battery if possible. When performed, put all of these things to dry and proceed to the next step.
Aspire the water that is in your Crosscall Trekker-X4
By using a straw, you must suck up the water that is contained in your Crosscall Trekker-X4. For this, you only need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Crosscall Trekker-X4, you will have the capacity to start drying it.
Dry the Crosscall Trekker-X4
The fourth step is to dry the phone. For this, we recommend you to put it in front of a ventilator a number of hours. Prevent using methods that cause the phone to heat up or damage the phone. When it is finished, we recommend you to leave the Crosscall Trekker-X4 in rice for 24 or 48 hours. The rice will consequently absorb the wetness that stays in the Crosscall Trekker-X4.
Reassemble the components and turn on the Crosscall Trekker-X4
When you have completed the prior steps, your Crosscall Trekker-X4 should be dry. So now you can try to turn on the Crosscall Trekker-X4. If this does not perform, we recommend you to hold out a few days or to bring the Crosscall Trekker-X4 to a repairshop.
What should not be done if the Crosscall Trekker-X4 has fallen into the water
There are a number of points not to accomplish when ever your Crosscall Trekker-X4 has fallen into the water. The 1st is to try to turn the phone back on just after. This can destroy the Crosscall Trekker-X4. Next, it is strongly suggested not to use a heat source to dry the Crosscall Trekker-X4. Certainly, methods which include oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the phone, do not shake it. Certainly, it could as well ruin the Crosscall Trekker-X4.
