Whether in the toilet or in a pool, it from time to time happens that the Blackview A7 is slipped in the water. Nonetheless, it’s not because a mobile has fallen in the water that it is undoubtedly dead. In truth, it is possible to redo an Blackview A7 that has fallen in the water. To do this, it is important to respect particular actions. People typically have bad reflexes and this is what can deteriorate the Blackview A7. We will first of all discover the steps to be taken after the Blackview A7 has fallen into the water. We will discover in the 2nd place the classical mistakes that a good number of people make.
Steps to follow in cases where your Blackview A7 fell into the water
If perhaps you need to restore your Blackview A7 in operating order, we advise that you follow the steps listed below.
Do not try to turn the Blackview A7 back on after exiting the water
One thing to perform when the Blackview A7 has fallen into the water is to turn off the mobile. In truth, in cases where it did not turn off, turn it off without doing any other tricks. If it is already off, do not try to turn it back on for the moment. If the Blackview A7 is switched on and wet, you might produce a short circuit and therefore toast the mobile.
Remove detachable components
When the Blackview A7 is out of the water and switched off, it will have to be disassembled to the highest possible. This means that it will be important to remove the shell, the SIM card, the SD card and the electric battery if possible. When performed, put all of these items to dry and continue to the following step.
Aspire the water that is in your Blackview A7
By using a straw, you must suck up the water that is contained in your Blackview A7. For this, you simply need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Blackview A7, you will be ready to start drying it.
Dry the Blackview A7
The fourth step is to dry the mobile. For this, we recommend you to put it in front of a ventilator several hours. Prevent using methods that cause the mobile to heat up or damage the mobile. When it is performed, we recommend you to leave the Blackview A7 in rice for 24 or 48 hours. The rice will therefore absorb the moisture that stays in the Blackview A7.
Reassemble the components and turn on the Blackview A7
When you have completed the previous steps, your Blackview A7 should be dry. So now you can try to turn on the Blackview A7. If this does not do the job, we recommend you to hang on a few days or to bring the Blackview A7 to a repairman.
What should not be done in cases where the Blackview A7 has fallen into the water
You will find several points not to perform when ever your Blackview A7 has fallen into the water. The first of all is to try to turn the mobile back on just after. This can demolish the Blackview A7. Following, it is highly advised not to use a heat source to dry the Blackview A7. Certainly, methods which include oven or hair dryer heat the components and may deteriorate them. Finally, to get the water out of the mobile, do not shake it. Certainly, it could additionally damage the Blackview A7.
