Whether in the toilet or in a pool, it sometimes happens that the Black Shark 2 is dropped in the water. On the other hand, it isn’t because a telephone has fallen in the water that it is obviously dead. Certainly, it is possible to redo an Black Shark 2 that has fallen in the water. To do this, it is important to respect certain steps. People generally have bad reflexes and this is what can degrade the Black Shark 2. We will 1st see the steps to be taken after the Black Shark 2 has fallen into the water. We will see in the secondary place the common errors that most people make.
Methods to follow in the event that your Black Shark 2 fell into the water
If perhaps you desire to restore your Black Shark 2 in operating order, we advise that you follow the steps listed below.
Do not attempt to turn the Black Shark 2 back on after getting out the water
The first thing to perform when the Black Shark 2 has fallen into the water is to shut off the telephone. Certainly, in the event that it did not turn off, turn it off without doing any other tricks. In cases where it is already off, do not attempt to turn it back on for the moment. In cases where the Black Shark 2 is started and wet, you could produce a short circuit and consequently toast the telephone.
Remove detachable components
When the Black Shark 2 is out of the water and switched off, it will have to be disassembled to the highest possible. Meaning that it will probably be important to take away the shell, the SIM card, the SD card and the electric battery if possible. When finished, put all of these things to dry and proceed to the following step.
Aspire the water that is in your Black Shark 2
Using a straw, you will need to suck up the water that is contained in your Black Shark 2. For doing it, you merely have to glue the straw over areas like buttons and vacuum. When you think you have aspired all the water from your Black Shark 2, you will be able to start drying it.
Dry the Black Shark 2
The fourth step is to dry the telephone. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using procédures that cause the telephone to heat up or damage the telephone. When it is completed, we advise you to leave the Black Shark 2 in rice for 24 or 48 hours. The rice will consequently absorb the wetness that remains in the Black Shark 2.
Reassemble the components and turn on the Black Shark 2
When you have completed the previous steps, your Black Shark 2 should be dry. So now you can make an attempt to turn on the Black Shark 2. If perhaps this doesn’t work, we advise you to wait some days or to bring the Black Shark 2 to a repairman.
What should not be done in the event that the Black Shark 2 has fallen into the water
You will find a number of points not to perform when ever your Black Shark 2 has fallen into the water. The 1st is to make an attempt to turn the telephone back on just after. This can demolish the Black Shark 2. Following, it is strongly advised not to use a heat source to dry the Black Shark 2. In fact, methods such as oven or hair dryer heat the components and may degrade them. At last, to get the water out of the telephone, do not shake it. In fact, it could also ruin the Black Shark 2.
