Whether in the toilet or in a pool, it sometimes occurs that the Wileyfox Spark is slipped in the water. Even so, it is not simply because a mobile phone has fallen in the water that it is inevitably dead. In fact, it is feasible to redo an Wileyfox Spark that has fallen in the water. To achieve this, it is needed to respect specific steps. People typically have bad reflexes and this is what can degrade the Wileyfox Spark. We will 1st discover the methods to be taken after the Wileyfox Spark has fallen into the water. We will discover in the 2nd place the common mistakes that a large number of people make.
Steps to follow in cases where your Wileyfox Spark fell into the water
In the event that you need to recover your Wileyfox Spark in operating order, we highly recommend that you follow the steps listed below.
Do not try to turn the Wileyfox Spark back on after getting out the water
The first thing to accomplish when the Wileyfox Spark has fallen into the water is to switch off the mobile phone. In fact, in cases where it did not turn off, turn it off without doing any other tricks. In the event that it is already off, do not try to turn it back on for the moment. In the event that the Wileyfox Spark is started and wet, you can produce a short circuit and therefore toast the mobile phone.
Remove detachable components
When the Wileyfox Spark is out of the water and switched off, it will have to be disassembled to the highest possible. This means that it’ll be needed to take away the shell, the SIM card, the SD card and the electric battery if possible. When performed, put all of these items to dry and proceed to the next step.
Aspire the water that is in your Wileyfox Spark
Using a straw, you will need to suck up the water that is contained in your Wileyfox Spark. For doing it, you simply have to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Wileyfox Spark, you will have the ability to start drying it.
Dry the Wileyfox Spark
The fourth step is to dry the mobile phone. For this, we advise you to put it in front of a ventilator several hours. Prevent using procédures that cause the mobile phone to heat up or damage the mobile phone. When it is finished, we advise you to leave the Wileyfox Spark in rice for 24 or 48 hours. The rice will therefore absorb the moisture that remains in the Wileyfox Spark.
Reassemble the components and turn on the Wileyfox Spark
When you have completed the prior steps, your Wileyfox Spark should be dry. So now you can try to turn on the Wileyfox Spark. If perhaps this doesn’t perform, we advise you to hold out some days or to bring the Wileyfox Spark to a repairman.
What should not be done in cases where the Wileyfox Spark has fallen into the water
There are several stuff not to accomplish when your Wileyfox Spark has fallen into the water. The 1st is to try to turn the mobile phone back on just after. This can kill the Wileyfox Spark. Following, it is strongly recommended not to use a heat source to dry the Wileyfox Spark. Indeed, techniques such as oven or hair dryer heat the components and may degrade them. At last, to get the water out of the mobile phone, do not shake it. Indeed, it could additionally ruin the Wileyfox Spark.
