How to fix a water damaged on Wiko WIM

Whether in the wc or in a swimming pool, it sometimes happens that the Wiko WIM is dropped into the water. Nevertheless, it isn’t because a phone has fallen into the water that it is undoubtedly dead. Indeed, it is possible to redo an Wiko WIM that has fallen into the water. To accomplish this, it is essential to respect specific steps. People often have bad reflexes and this is what can damage the Wiko WIM. We will 1st discover the techniques to be taken after the Wiko WIM has fallen into the water. We will discover in the 2nd place the common errors that many people make.water-damaged-wiko-wim

Steps to follow in the event that your Wiko WIM fell into the water

Whenever you wish to restore your Wiko WIM in operating order, we recommend that you follow the steps below.

Do not attempt to turn the Wiko WIM back on after exiting the water

The very first thing to do when the Wiko WIM has fallen into the water is to switch off the phone. Indeed, in the event that it did not switch off, turn it off without doing any other tricks. In cases where it is already off, do not attempt to turn it back on for the moment. In cases where the Wiko WIM is started and wet, you can make a short circuit and therefore toast the phone.

Remove detachable components

When the Wiko WIM is out of the water and switched off, it will have to be disassembled to the maximum. This means that it will be essential to remove the shell, the SIM card, the SD card and the electric battery if possible. When completed, put all of these things to dry and proceed to the following step.

Aspire the water that is in your Wiko WIM

By using a straw, you have got to suck up the water that is contained in your Wiko WIM. For this, you simply have to glue the straw over areas like buttons and vacuum. When you think you have aspired all the water from your Wiko WIM, you will have the capacity to start drying it.

Dry the Wiko WIM

The fourth step is to dry the phone. For this, we recommend you to put it in front of a ventilator several hours. Avoid using méthodes that cause the phone to heat up or damage the phone. When it is performed, we recommend you to leave the Wiko WIM in rice for 24 or 48 hours. The rice will therefore absorb the wetness that stays in the Wiko WIM.

Reassemble the components and turn on the Wiko WIM

When you have completed the prior steps, your Wiko WIM should be dry. So now you can make an attempt to turn on the Wiko WIM. If this doesn’t perform, we recommend you to wait a couple of days or to bring the Wiko WIM to a repairman.

What should not be done in the event that the Wiko WIM has fallen into the water

There are several things not to do when your Wiko WIM has fallen into the water. The 1st is to make an attempt to turn the phone back on just after. This can kill the Wiko WIM. Next, it is highly suggested not to use a heat source to dry the Wiko WIM. In fact, methods which include oven or hair dryer heat the components and may damage them. At last, to get the water out of the phone, do not shake it. In fact, it could as well damage the Wiko WIM.