Whether in the wc or in a swimming pool, it from time to time occurs that the Wiko ROBBY is slipped into the water. Nevertheless, it is not simply because a mobile has fallen into the water that it is unavoidably dead. Certainly, it is possible to redo an Wiko ROBBY that has fallen into the water. To accomplish this, it is important to respect certain steps. People often have bad reflexes and this is what can damage the Wiko ROBBY. We will 1st see the steps to be taken after the Wiko ROBBY has fallen into the water. We will see in the secondary place the classical errors that a large number of people make.
Methods to follow in cases where your Wiko ROBBY fell into the water
If perhaps you desire to recover your Wiko ROBBY in working order, we advise that you follow the steps listed below.
Do not try to turn the Wiko ROBBY back on after getting out the water
One thing to perform when the Wiko ROBBY has fallen into the water is to switch off the mobile. Certainly, in cases where it didn’t turn off, turn it off without doing any other tricks. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Wiko ROBBY is started and wet, you might generate a short circuit and therefore toast the mobile.
Remove detachable components
When the Wiko ROBBY is out of the water and switched off, it will have to be disassembled to the maximum. This implies that it will be important to remove the shell, the SIM card, the SD card and the electric battery if possible. When finished, put all of these things to dry and proceed to the next step.
Aspire the water that is in your Wiko ROBBY
Utilizing a straw, you must suck up the water that is contained in your Wiko ROBBY. For this, you just need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Wiko ROBBY, you will have the capacity to start drying it.
Dry the Wiko ROBBY
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator several hours. Avoid using méthodes that cause the mobile to heat up or damage the mobile. When it is performed, we advise you to leave the Wiko ROBBY in rice for 24 or 48 hours. The rice will therefore absorb the wetness that remains in the Wiko ROBBY.
Reassemble the components and turn on the Wiko ROBBY
When you have completed the previous steps, your Wiko ROBBY should be dry. So now you can try to turn on the Wiko ROBBY. If this does not do the job, we advise you to wait a few days or to bring the Wiko ROBBY to a repairman.
What should not be done in cases where the Wiko ROBBY has fallen into the water
There are several things not to perform when ever your Wiko ROBBY has fallen into the water. The 1st is to try to turn the mobile back on just after. This can kill the Wiko ROBBY. Next, it is strongly suggested not to use a heat source to dry the Wiko ROBBY. Without a doubt, solutions which include oven or hair dryer heat the components and may damage them. Finally, to get the water out of the mobile, do not shake it. In fact, it could also ruin the Wiko ROBBY.
