Whether in the toilet or in a pool, it sometimes occurs that the Wiko Ridge Fab is dropped into the water. Even so, it isn’t because a mobile has fallen into the water that it’s obviously dead. Certainly, it is possible to redo an Wiko Ridge Fab that has fallen into the water. To get this done, it is necessary to respect particular steps. People generally have bad reflexes and this is what can deteriorate the Wiko Ridge Fab. We will 1st see the steps to be taken after the Wiko Ridge Fab has fallen into the water. We will see in the second place the common errors that a good number of people make.
Steps to follow if your Wiko Ridge Fab fell into the water
If perhaps you need to restore your Wiko Ridge Fab in working order, we advise that you follow the steps listed below.
Do not attempt to turn the Wiko Ridge Fab back on after getting out the water
The first thing to perform when the Wiko Ridge Fab has fallen into the water is to turn off the mobile. Certainly, if it did not switch off, turn it off without doing any other manipulation. In cases where it is already off, do not attempt to turn it back on for the moment. In cases where the Wiko Ridge Fab is turned on and wet, you could make a short circuit and consequently toast the mobile.
Remove detachable components
When the Wiko Ridge Fab is out of the water and turned off, it will have to be disassembled to the maximum. Meaning that it will be necessary to remove the shell, the SIM card, the SD card and the battery if possible. When done, put all of these things to dry and proceed to the next step.
Aspire the water that is in your Wiko Ridge Fab
Employing a straw, you must suck up the water that is contained in your Wiko Ridge Fab. For this, you only need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Wiko Ridge Fab, you will have the ability to start drying it.
Dry the Wiko Ridge Fab
The fourth step is to dry the mobile. For this, we suggest you to put it in front of a ventilator several hours. Avoid using méthodes that cause the mobile to heat up or damage the mobile. When it is performed, we suggest you to leave the Wiko Ridge Fab in rice for 24 or 48 hours. The rice will consequently absorb the wetness that stays in the Wiko Ridge Fab.
Reassemble the components and turn on the Wiko Ridge Fab
When you have completed the prior steps, your Wiko Ridge Fab should be dry. So now you can make an attempt to turn on the Wiko Ridge Fab. In the event that this does not work, we suggest you to hold out a few days or to bring the Wiko Ridge Fab to a repairman.
What should not be done if the Wiko Ridge Fab has fallen into the water
There are several stuff not to perform when your Wiko Ridge Fab has fallen into the water. The 1st is to make an attempt to turn the mobile back on just after. This can kill the Wiko Ridge Fab. Next, it is strongly recommended not to use a heat source to dry the Wiko Ridge Fab. Indeed, methods which include oven or hair dryer heat the components and may deteriorate them. Finally, to get the water out of the mobile, do not shake it. In fact, it could additionally damage the Wiko Ridge Fab.
