Whether in the wc or in a pool, it from time to time happens that the Wiko Pulp Fab is slipped into the water. Nonetheless, it is not simply because a mobile has fallen into the water that it is obviously dead. Certainly, it is possible to redo an Wiko Pulp Fab that has fallen into the water. To get this done, it is necessary to respect certain actions. People typically have bad reflexes and this is what can degrade the Wiko Pulp Fab. We will first of all discover the steps to be taken after the Wiko Pulp Fab has fallen into the water. We will discover in the second place the common mistakes that a good number of people make.
Methods to follow if perhaps your Wiko Pulp Fab fell into the water
Whenever you want to recover your Wiko Pulp Fab in working order, we recommend that you follow the steps below.
Don’t attempt to turn the Wiko Pulp Fab back on after exiting the water
One thing to do when the Wiko Pulp Fab has fallen into the water is to turn off the mobile. Certainly, if perhaps it didn’t turn off, turn it off without doing any other manipulation. In the event that it is already off, do not attempt to turn it back on for the moment. In the event that the Wiko Pulp Fab is turned on and wet, you can make a short circuit and consequently toast the mobile.
Remove detachable components
Once the Wiko Pulp Fab is out of the water and switched off, it will have to be disassembled to the maximum. Meaning that it will be necessary to take out the shell, the SIM card, the SD card and the battery if possible. Once done, put all of these things to dry and continue to the following step.
Aspire the water that is in your Wiko Pulp Fab
Utilizing a straw, you must suck up the water that is contained in your Wiko Pulp Fab. For doing it, you just need to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your Wiko Pulp Fab, you will have the capacity to start drying it.
Dry the Wiko Pulp Fab
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using solutions that cause the mobile to heat up or damage the mobile. Once it is completed, we advise you to leave the Wiko Pulp Fab in rice for 24 or 48 hours. The rice will consequently absorb the wetness that remains in the Wiko Pulp Fab.
Reassemble the components and turn on the Wiko Pulp Fab
When you have completed the previous steps, your Wiko Pulp Fab should be dry. So now you can try to turn on the Wiko Pulp Fab. If perhaps this does not work, we advise you to hold out a couple of days or to bring the Wiko Pulp Fab to a repairman.
What should not be done if perhaps the Wiko Pulp Fab has fallen into the water
You will find a number of stuff not to do when ever your Wiko Pulp Fab has fallen into the water. The first of all is to try to turn the mobile back on just after. This can kill the Wiko Pulp Fab. Next, it is strongly suggested not to use a heat source to dry the Wiko Pulp Fab. Indeed, solutions which include oven or hair dryer heat the components and may degrade them. At last, to get the water out of the mobile, do not shake it. Certainly, it could also ruin the Wiko Pulp Fab.
