Whether in the toilet or in a swimming pool, it sometimes happens that the Wiko Highway Signs is slipped in the water. Even so, it’s not simply because a mobile has fallen in the water that it’s unavoidably dead. Indeed, it is feasible to redo an Wiko Highway Signs that has fallen in the water. To accomplish this, it is essential to respect particular actions. People generally have bad reflexes and this is what can damage the Wiko Highway Signs. We will first see the steps to be taken after the Wiko Highway Signs has fallen into the water. We will see in the second place the classical mistakes that the majority of people make.
Steps to follow in cases where your Wiko Highway Signs fell into the water
If you wish to recover your Wiko Highway Signs in working order, we advise that you follow the steps below.
Do not try to turn the Wiko Highway Signs back on after getting out the water
The very first thing to do when the Wiko Highway Signs has fallen into the water is to switch off the mobile. Indeed, in cases where it didn’t switch off, turn it off without doing any other manipulation. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the Wiko Highway Signs is turned on and wet, you may produce a short circuit and as a result toast the mobile.
Remove detachable components
When the Wiko Highway Signs is out of the water and switched off, it will have to be disassembled to the maximum. This implies that it will probably be essential to take away the shell, the SIM card, the SD card and the electric battery if possible. When performed, put all of these items to dry and proceed to the following step.
Aspire the water that is in your Wiko Highway Signs
Employing a straw, you have got to suck up the water that is contained in your Wiko Highway Signs. For doing it, you simply need to glue the straw over areas like buttons and vacuum. When you think you have aspired all the water from your Wiko Highway Signs, you will have the capacity to start drying it.
Dry the Wiko Highway Signs
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using techniques that cause the mobile to heat up or damage the mobile. When it is done, we advise you to leave the Wiko Highway Signs in rice for 24 or 48 hours. The rice will as a result absorb the moisture that stays in the Wiko Highway Signs.
Reassemble the components and turn on the Wiko Highway Signs
When you have completed the prior steps, your Wiko Highway Signs should be dry. So now you can make an attempt to turn on the Wiko Highway Signs. If perhaps this doesn’t perform, we advise you to wait a couple of days or to bring the Wiko Highway Signs to a repairman.
What should not be done in cases where the Wiko Highway Signs has fallen into the water
You will find a number of points not to do when your Wiko Highway Signs has fallen into the water. The first is to make an attempt to turn the mobile back on just after. This can destroy the Wiko Highway Signs. Next, it is strongly recommended not to use a heat source to dry the Wiko Highway Signs. Indeed, methods such as oven or hair dryer heat the components and may damage them. Finally, to get the water out of the mobile, do not shake it. Certainly, it could additionally ruin the Wiko Highway Signs.
