Whether in the toilet or in a swimming pool, it occasionally occurs that the Wiko Harry 2 is dropped into the water. On the other hand, it isn’t simply because a mobile phone has fallen into the water that it is undoubtedly dead. In fact, it is feasible to redo an Wiko Harry 2 that has fallen into the water. To accomplish this, it is necessary to respect certain actions. People generally have bad reflexes and this is what can damage the Wiko Harry 2. We will 1st see the steps to be taken after the Wiko Harry 2 has fallen into the water. We will see in the secondary place the classical mistakes that a good number of people make.
Steps to follow in the event that your Wiko Harry 2 fell into the water
If you wish to restore your Wiko Harry 2 in operating order, we advise that you follow the steps listed below.
Don’t attempt to turn the Wiko Harry 2 back on after getting out the water
The very first thing to perform when the Wiko Harry 2 has fallen into the water is to switch off the mobile phone. In fact, in the event that it didn’t switch off, turn it off without doing any other tricks. If perhaps it is already off, do not attempt to turn it back on for the moment. If perhaps the Wiko Harry 2 is switched on and wet, you may make a short circuit and therefore toast the mobile phone.
Remove detachable components
Once the Wiko Harry 2 is out of the water and switched off, it will have to be disassembled to the highest possible. Meaning that it will probably be necessary to take out the shell, the SIM card, the SD card and the electric battery if possible. Once finished, put all of these items to dry and continue to the following step.
Aspire the water that is in your Wiko Harry 2
By using a straw, you have got to suck up the water that is contained in your Wiko Harry 2. For this, you just have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Wiko Harry 2, you will be ready to start drying it.
Dry the Wiko Harry 2
The fourth step is to dry the mobile phone. For this, we recommend you to put it in front of a ventilator several hours. Prevent using techniques that cause the mobile phone to heat up or damage the mobile phone. Once it is completed, we recommend you to leave the Wiko Harry 2 in rice for 24 or 48 hours. The rice will therefore absorb the wetness that stays in the Wiko Harry 2.
Reassemble the components and turn on the Wiko Harry 2
When you have completed the previous steps, your Wiko Harry 2 should be dry. So now you can try to turn on the Wiko Harry 2. If perhaps this doesn’t perform, we recommend you to wait a couple of days or to bring the Wiko Harry 2 to a repairman.
What should not be done in the event that the Wiko Harry 2 has fallen into the water
You will find several things not to perform when your Wiko Harry 2 has fallen into the water. The 1st is to try to turn the mobile phone back on just after. This can kill the Wiko Harry 2. Following, it is strongly suggested not to use a heat source to dry the Wiko Harry 2. Without a doubt, solutions such as oven or hair dryer heat the components and may damage them. Finally, to get the water out of the mobile phone, do not shake it. Indeed, it could also ruin the Wiko Harry 2.
