How to fix a water damaged on Wiko Barry

Whether in the wc or in a swimming pool, it occasionally occurs that the Wiko Barry is dropped into the water. On the other hand, it is not because a telephone has fallen into the water that it’s inevitably dead. In fact, it is possible to redo an Wiko Barry that has fallen into the water. To achieve this, it is required to respect certain actions. People generally have bad reflexes and this is what can degrade the Wiko Barry. We will first of all see the techniques to be taken after the Wiko Barry has fallen into the water. We will see in the second place the common mistakes that a good number of people make.water-damaged-Wiko-Barry

Methods to follow in cases where your Wiko Barry fell into the water

In the event that you desire to recover your Wiko Barry in working order, we highly recommend that you follow the steps listed below.

Don’t attempt to turn the Wiko Barry back on after getting out the water

The first thing to do when the Wiko Barry has fallen into the water is to turn off the telephone. In fact, in cases where it didn’t switch off, turn it off without doing any other manipulation. If perhaps it is already off, do not attempt to turn it back on for the moment. If perhaps the Wiko Barry is switched on and wet, you might generate a short circuit and therefore toast the telephone.

Remove detachable components

When the Wiko Barry is out of the water and turned off, it will have to be disassembled to the maximum. Meaning that it will probably be required to take away the shell, the SIM card, the SD card and the battery if possible. When carried out, put all of these things to dry and proceed to the following step.

Aspire the water that is in your Wiko Barry

Utilizing a straw, you will need to suck up the water that is contained in your Wiko Barry. For this, you simply need to glue the straw over areas like buttons and vacuum. When you think you have aspired all the water from your Wiko Barry, you will be ready to start drying it.

Dry the Wiko Barry

The fourth step is to dry the telephone. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using techniques that cause the telephone to heat up or damage the telephone. When it is finished, we advise you to leave the Wiko Barry in rice for 24 or 48 hours. The rice will therefore absorb the wetness that stays in the Wiko Barry.

Reassemble the components and turn on the Wiko Barry

When you have completed the prior steps, your Wiko Barry should be dry. So now you can make an attempt to turn on the Wiko Barry. If perhaps this doesn’t do the job, we advise you to wait some days or to bring the Wiko Barry to a repairman.

What should not be done in cases where the Wiko Barry has fallen into the water

You will find a number of points not to do when your Wiko Barry has fallen into the water. The first of all is to make an attempt to turn the telephone back on just after. This can kill the Wiko Barry. Next, it is strongly advised not to use a heat source to dry the Wiko Barry. In fact, methods such as oven or hair dryer heat the components and may degrade them. At last, to get the water out of the telephone, do not shake it. In fact, it could additionally damage the Wiko Barry.