Whether in the toilet or in a pool, it occasionally happens that the Motorola is dropped into the water. Nonetheless, it is not simply because a mobile has fallen into the water that it is inevitably dead. Certainly, it is feasible to redo an Motorola that has fallen into the water. To get this done, it is needed to respect specific actions. People typically have bad reflexes and this is what can degrade the Motorola. We will first of all discover the steps to be taken after the Motorola has fallen into the water. We will discover in the second place the classical mistakes that a good number of people make.
Methods to follow in cases where your Motorola fell into the water
If perhaps you need to restore your Motorola in operating order, we highly recommend that you follow the steps below.
Don’t try to turn the Motorola back on after exiting the water
The very first thing to perform when the Motorola has fallen into the water is to shut off the mobile. Certainly, in cases where it didn’t switch off, turn it off without doing any other manipulation. In the event that it is already off, do not try to turn it back on for the moment. In the event that the Motorola is turned on and wet, you can make a short circuit and as a result toast the mobile.
Remove detachable components
Once the Motorola is out of the water and turned off, it will have to be disassembled to the maximum. Meaning that it will probably be needed to take out the shell, the SIM card, the SD card and the battery if possible. Once carried out, put all of these things to dry and continue to the following step.
Aspire the water that is in your Motorola
Utilizing a straw, you will have to suck up the water that is contained in your Motorola. For this, you simply have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Motorola, you will have the capacity to start drying it.
Dry the Motorola
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using solutions that cause the mobile to heat up or damage the mobile. Once it is performed, we advise you to leave the Motorola in rice for 24 or 48 hours. The rice will as a result absorb the moisture that remains in the Motorola.
Reassemble the components and turn on the Motorola
When you have completed the previous steps, your Motorola should be dry. So now you can make an attempt to turn on the Motorola. If perhaps this does not perform, we advise you to hang on a couple of days or to bring the Motorola to a repairshop.
What should not be done in cases where the Motorola has fallen into the water
You will find a number of stuff not to perform when your Motorola has fallen into the water. The first of all is to make an attempt to turn the mobile back on just after. This can destroy the Motorola. Following, it is strongly suggested not to use a heat source to dry the Motorola. Without a doubt, solutions such as oven or hair dryer heat the components and may degrade them. Finally, to get the water out of the mobile, do not shake it. Indeed, it could additionally damage the Motorola.
