Whether in the toilet or in a pool, it from time to time happens that the Medion Life X6001 is dropped in the water. However, it is not because a mobile has fallen in the water that it is inevitably dead. In truth, it is feasible to redo an Medion Life X6001 that has fallen in the water. To achieve this, it is needed to respect specific steps. People typically have bad reflexes and this is what can deteriorate the Medion Life X6001. We will first discover the steps to be taken after the Medion Life X6001 has fallen into the water. We will discover in the second place the classical mistakes that a good number of people make.
Methods to follow in the event that your Medion Life X6001 fell into the water
Whenever you wish to recover your Medion Life X6001 in operating order, we advise that you follow the steps below.
Don’t try to turn the Medion Life X6001 back on after exiting the water
The very first thing to perform when the Medion Life X6001 has fallen into the water is to turn off the mobile. In truth, in the event that it did not turn off, turn it off without doing any other manipulation. In cases where it is already off, do not try to turn it back on for the moment. In cases where the Medion Life X6001 is switched on and wet, you can create a short circuit and consequently toast the mobile.
Remove detachable components
Once the Medion Life X6001 is out of the water and switched off, it will have to be disassembled to the highest possible. Meaning that it will probably be needed to take out the shell, the SIM card, the SD card and the electric battery if possible. Once completed, put all of these things to dry and proceed to the next step.
Aspire the water that is in your Medion Life X6001
Using a straw, you must suck up the water that is contained in your Medion Life X6001. For this, you just need to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Medion Life X6001, you will have the ability to start drying it.
Dry the Medion Life X6001
The fourth step is to dry the mobile. For this, we suggest you to put it in front of a ventilator several hours. Prevent using solutions that cause the mobile to heat up or damage the mobile. Once it is finished, we suggest you to leave the Medion Life X6001 in rice for 24 or 48 hours. The rice will consequently absorb the wetness that remains in the Medion Life X6001.
Reassemble the components and turn on the Medion Life X6001
When you have completed the prior steps, your Medion Life X6001 should be dry. So now you can try to turn on the Medion Life X6001. If perhaps this doesn’t function, we suggest you to wait a couple of days or to bring the Medion Life X6001 to a repairshop.
What should not be done in the event that the Medion Life X6001 has fallen into the water
There are several points not to perform when your Medion Life X6001 has fallen into the water. The first is to try to turn the mobile back on just after. This can kill the Medion Life X6001. Following, it is strongly recommended not to use a heat source to dry the Medion Life X6001. Without a doubt, methods which include oven or hair dryer heat the components and may deteriorate them. Finally, to get the water out of the mobile, do not shake it. Certainly, it could as well ruin the Medion Life X6001.
