Whether in the toilet or in a swimming pool, it sometimes happens that the Marshall London is dropped in the water. However, it isn’t simply because a mobile has fallen in the water that it is obviously dead. In truth, it is possible to redo an Marshall London that has fallen in the water. To do this, it is needed to respect specific steps. People often have bad reflexes and this is what can deteriorate the Marshall London. We will 1st see the techniques to be taken after the Marshall London has fallen into the water. We will see in the secondary place the classical mistakes that many people make.
Steps to follow if perhaps your Marshall London fell into the water
Whenever you need to restore your Marshall London in operating order, we advise that you follow the steps below.
Don’t try to turn the Marshall London back on after exiting the water
The very first thing to do when the Marshall London has fallen into the water is to turn off the mobile. In truth, if perhaps it did not turn off, turn it off without doing any other manipulation. If it is already off, do not try to turn it back on for the moment. If the Marshall London is started and wet, you might make a short circuit and therefore toast the mobile.
Remove detachable components
When the Marshall London is out of the water and turned off, it will have to be disassembled to the highest possible. This means that it will be needed to take out the shell, the SIM card, the SD card and the battery if possible. When finished, put all of these things to dry and continue to the following step.
Aspire the water that is in your Marshall London
By using a straw, you will need to suck up the water that is contained in your Marshall London. For doing it, you simply need to glue the straw over areas like buttons and vacuum. When you believe you have aspired all the water from your Marshall London, you will be ready to start drying it.
Dry the Marshall London
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using procédures that cause the mobile to heat up or damage the mobile. When it is finished, we advise you to leave the Marshall London in rice for 24 or 48 hours. The rice will therefore absorb the moisture that remains in the Marshall London.
Reassemble the components and turn on the Marshall London
When you have completed the prior steps, your Marshall London should be dry. So now you can try to turn on the Marshall London. If perhaps this doesn’t work, we advise you to wait a couple of days or to bring the Marshall London to a repairshop.
What should not be done if perhaps the Marshall London has fallen into the water
You will find a number of things not to do when ever your Marshall London has fallen into the water. The 1st is to try to turn the mobile back on just after. This can destroy the Marshall London. Next, it is strongly recommended not to use a heat source to dry the Marshall London. Certainly, solutions such as oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the mobile, do not shake it. Certainly, it could likewise damage the Marshall London.
