Whether in the toilet or in a pool, it occasionally occurs that the Landvo V1 is slipped into the water. Nevertheless, it is not because a phone has fallen into the water that it’s obviously dead. In truth, it is possible to redo an Landvo V1 that has fallen into the water. To get this done, it is important to respect certain steps. People generally have bad reflexes and this is what can damage the Landvo V1. We will 1st see the techniques to be taken after the Landvo V1 has fallen into the water. We will see in the 2nd place the common mistakes that most people make.
Steps to follow if perhaps your Landvo V1 fell into the water
In the event that you wish to recover your Landvo V1 in working order, we highly recommend that you follow the steps below.
Do not try to turn the Landvo V1 back on after exiting the water
The very first thing to accomplish when the Landvo V1 has fallen into the water is to switch off the phone. In truth, if perhaps it didn’t turn off, turn it off without doing any other manipulation. In cases where it is already off, do not try to turn it back on for the moment. In cases where the Landvo V1 is started and wet, you might produce a short circuit and therefore toast the phone.
Remove detachable components
Once the Landvo V1 is out of the water and turned off, it will have to be disassembled to the maximum. Meaning that it’ll be important to take away the shell, the SIM card, the SD card and the battery if possible. Once completed, put all of these things to dry and proceed to the following step.
Aspire the water that is in your Landvo V1
Utilizing a straw, you have got to suck up the water that is contained in your Landvo V1. For this, you just need to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Landvo V1, you will be ready to start drying it.
Dry the Landvo V1
The fourth step is to dry the phone. For this, we advise you to put it in front of a ventilator several hours. Prevent using methods that cause the phone to heat up or damage the phone. Once it is performed, we advise you to leave the Landvo V1 in rice for 24 or 48 hours. The rice will therefore absorb the wetness that stays in the Landvo V1.
Reassemble the components and turn on the Landvo V1
When you have completed the previous steps, your Landvo V1 should be dry. So now you can try to turn on the Landvo V1. If perhaps this doesn’t perform, we advise you to wait a couple of days or to bring the Landvo V1 to a repairman.
What should not be done if perhaps the Landvo V1 has fallen into the water
There are several things not to accomplish when your Landvo V1 has fallen into the water. The 1st is to try to turn the phone back on just after. This can kill the Landvo V1. Following, it is highly advised not to use a heat source to dry the Landvo V1. In fact, solutions which include oven or hair dryer heat the components and may damage them. At last, to get the water out of the phone, do not shake it. Certainly, it could as well ruin the Landvo V1.
