Whether in the wc or in a swimming pool, it sometimes occurs that the Kyocera Torque is dropped into the water. Even so, it’s not simply because a phone has fallen into the water that it’s inevitably dead. In fact, it is feasible to redo an Kyocera Torque that has fallen into the water. To achieve this, it is needed to respect certain actions. People generally have bad reflexes and this is what can damage the Kyocera Torque. We will 1st discover the methods to be taken after the Kyocera Torque has fallen into the water. We will discover in the 2nd place the common mistakes that a large number of people make.
Methods to follow if perhaps your Kyocera Torque fell into the water
In the event that you want to recover your Kyocera Torque in operating order, we advise that you follow the steps below.
Do not attempt to turn the Kyocera Torque back on after getting out the water
The very first thing to perform when the Kyocera Torque has fallen into the water is to switch off the phone. In fact, if perhaps it didn’t switch off, turn it off without doing any other tricks. In the event that it is already off, do not attempt to turn it back on for the moment. In the event that the Kyocera Torque is turned on and wet, you might produce a short circuit and as a result toast the phone.
Remove detachable components
When the Kyocera Torque is out of the water and switched off, it will have to be disassembled to the maximum. This implies that it’ll be needed to take out the shell, the SIM card, the SD card and the battery if possible. When carried out, put all of these things to dry and proceed to the following step.
Aspire the water that is in your Kyocera Torque
Using a straw, you must suck up the water that is contained in your Kyocera Torque. For doing it, you merely need to glue the straw over areas like buttons and vacuum. When you think you have aspired all the water from your Kyocera Torque, you will be ready to start drying it.
Dry the Kyocera Torque
The fourth step is to dry the phone. For this, we recommend you to put it in front of a ventilator a number of hours. Prevent using methods that cause the phone to heat up or damage the phone. When it is completed, we recommend you to leave the Kyocera Torque in rice for 24 or 48 hours. The rice will as a result absorb the moisture that remains in the Kyocera Torque.
Reassemble the components and turn on the Kyocera Torque
When you have completed the previous steps, your Kyocera Torque should be dry. So now you can try to turn on the Kyocera Torque. If perhaps this does not function, we recommend you to wait some days or to bring the Kyocera Torque to a repairshop.
What should not be done if perhaps the Kyocera Torque has fallen into the water
There are a number of stuff not to perform when your Kyocera Torque has fallen into the water. The 1st is to try to turn the phone back on just after. This can destroy the Kyocera Torque. Following, it is highly recommended not to use a heat source to dry the Kyocera Torque. Certainly, techniques which include oven or hair dryer heat the components and may damage them. At last, to get the water out of the phone, do not shake it. Indeed, it could likewise ruin the Kyocera Torque.
