Whether in the wc or in a pool, it from time to time happens that the HP Elite x3 is slipped in the water. Even so, it is not simply because a mobile phone has fallen in the water that it’s unavoidably dead. In truth, it is feasible to redo an HP Elite x3 that has fallen in the water. To do this, it is required to respect certain steps. People often have bad reflexes and this is what can deteriorate the HP Elite x3. We will 1st see the methods to be taken after the HP Elite x3 has fallen into the water. We will see in the second place the classical mistakes that a large number of people make.
Methods to follow in the event that your HP Elite x3 fell into the water
Whenever you wish to restore your HP Elite x3 in operating order, we highly recommend that you follow the steps listed below.
Do not try to turn the HP Elite x3 back on after exiting the water
The first thing to perform when the HP Elite x3 has fallen into the water is to turn off the mobile phone. In truth, in the event that it did not turn off, turn it off without doing any other manipulation. If perhaps it is already off, do not try to turn it back on for the moment. If perhaps the HP Elite x3 is started and wet, you may generate a short circuit and consequently toast the mobile phone.
Remove detachable components
Once the HP Elite x3 is out of the water and switched off, it will have to be disassembled to the highest possible. This implies that it will probably be required to take out the shell, the SIM card, the SD card and the electric battery if possible. Once carried out, put all of these items to dry and proceed to the next step.
Aspire the water that is in your HP Elite x3
By using a straw, you need to suck up the water that is contained in your HP Elite x3. For this, you merely have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your HP Elite x3, you will be able to start drying it.
Dry the HP Elite x3
The fourth step is to dry the mobile phone. For this, we suggest you to put it in front of a ventilator several hours. Prevent using méthodes that cause the mobile phone to heat up or damage the mobile phone. Once it is completed, we suggest you to leave the HP Elite x3 in rice for 24 or 48 hours. The rice will consequently absorb the moisture that stays in the HP Elite x3.
Reassemble the components and turn on the HP Elite x3
When you have completed the previous steps, your HP Elite x3 should be dry. So now you can make an attempt to turn on the HP Elite x3. If this does not function, we suggest you to wait a couple of days or to bring the HP Elite x3 to a repairman.
What should not be done in the event that the HP Elite x3 has fallen into the water
You will find several stuff not to perform when ever your HP Elite x3 has fallen into the water. The 1st is to make an attempt to turn the mobile phone back on just after. This can demolish the HP Elite x3. Next, it is highly recommended not to use a heat source to dry the HP Elite x3. In fact, techniques such as oven or hair dryer heat the components and may deteriorate them. Finally, to get the water out of the mobile phone, do not shake it. Indeed, it could also damage the HP Elite x3.
