Whether in the wc or in a swimming pool, it from time to time happens that the CUBOT Dinosaur is dropped into the water. However, it’s not because a telephone has fallen into the water that it’s undoubtedly dead. In truth, it is possible to redo an CUBOT Dinosaur that has fallen into the water. To get this done, it is essential to respect specific actions. People often have bad reflexes and this is what can deteriorate the CUBOT Dinosaur. We will first of all see the steps to be taken after the CUBOT Dinosaur has fallen into the water. We will see in the second place the common mistakes that most people make.
Steps to follow if perhaps your CUBOT Dinosaur fell into the water
If you desire to recover your CUBOT Dinosaur in working order, we advise that you follow the steps below.
Do not try to turn the CUBOT Dinosaur back on after exiting the water
The very first thing to accomplish when the CUBOT Dinosaur has fallen into the water is to turn off the telephone. In truth, if perhaps it didn’t turn off, turn it off without doing any other tricks. In cases where it is already off, do not try to turn it back on for the moment. In cases where the CUBOT Dinosaur is started and wet, you could create a short circuit and as a result toast the telephone.
Remove detachable components
Once the CUBOT Dinosaur is out of the water and turned off, it will have to be disassembled to the maximum. This means that it will probably be essential to remove the shell, the SIM card, the SD card and the electric battery if possible. Once completed, put all of these items to dry and proceed to the next step.
Aspire the water that is in your CUBOT Dinosaur
Using a straw, you will need to suck up the water that is contained in your CUBOT Dinosaur. For this, you only have to glue the straw over areas like buttons and vacuum. Once you believe you have aspired all the water from your CUBOT Dinosaur, you will have the capacity to start drying it.
Dry the CUBOT Dinosaur
The fourth step is to dry the telephone. For this, we recommend you to put it in front of a ventilator several hours. Avoid using procédures that cause the telephone to heat up or damage the telephone. Once it is finished, we recommend you to leave the CUBOT Dinosaur in rice for 24 or 48 hours. The rice will as a result absorb the wetness that remains in the CUBOT Dinosaur.
Reassemble the components and turn on the CUBOT Dinosaur
When you have completed the prior steps, your CUBOT Dinosaur should be dry. So now you can make an attempt to turn on the CUBOT Dinosaur. If perhaps this doesn’t work, we recommend you to hang on a couple of days or to bring the CUBOT Dinosaur to a repairshop.
What should not be done if perhaps the CUBOT Dinosaur has fallen into the water
There are several stuff not to accomplish when your CUBOT Dinosaur has fallen into the water. The first of all is to make an attempt to turn the telephone back on just after. This can kill the CUBOT Dinosaur. Following, it is highly suggested not to use a heat source to dry the CUBOT Dinosaur. Certainly, techniques which include oven or hair dryer heat the components and may deteriorate them. At last, to get the water out of the telephone, do not shake it. Certainly, it could additionally ruin the CUBOT Dinosaur.
