Whether in the toilet or in a swimming pool, it sometimes occurs that the Crosscall TREKKER-M1 is slipped in the water. Even so, it isn’t simply because a mobile has fallen in the water that it is undoubtedly dead. In fact, it is possible to redo an Crosscall TREKKER-M1 that has fallen in the water. To accomplish this, it is essential to respect specific actions. People often have bad reflexes and this is what can degrade the Crosscall TREKKER-M1. We will first discover the techniques to be taken after the Crosscall TREKKER-M1 has fallen into the water. We will discover in the second place the common errors that a large number of people make.
Steps to follow if perhaps your Crosscall TREKKER-M1 fell into the water
In the event that you wish to restore your Crosscall TREKKER-M1 in operating order, we highly recommend that you follow the steps listed below.
Don’t attempt to turn the Crosscall TREKKER-M1 back on after getting out the water
The very first thing to do when the Crosscall TREKKER-M1 has fallen into the water is to shut off the mobile. In fact, if perhaps it didn’t switch off, turn it off without doing any other tricks. In cases where it is already off, do not attempt to turn it back on for the moment. In cases where the Crosscall TREKKER-M1 is started and wet, you might make a short circuit and consequently toast the mobile.
Remove detachable components
Once the Crosscall TREKKER-M1 is out of the water and turned off, it will have to be disassembled to the maximum. This means that it will be essential to remove the shell, the SIM card, the SD card and the electric battery if possible. Once performed, put all of these items to dry and continue to the following step.
Aspire the water that is in your Crosscall TREKKER-M1
Employing a straw, you have got to suck up the water that is contained in your Crosscall TREKKER-M1. For this, you merely have to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Crosscall TREKKER-M1, you will be able to start drying it.
Dry the Crosscall TREKKER-M1
The fourth step is to dry the mobile. For this, we advise you to put it in front of a ventilator a number of hours. Avoid using procédures that cause the mobile to heat up or damage the mobile. Once it is completed, we advise you to leave the Crosscall TREKKER-M1 in rice for 24 or 48 hours. The rice will consequently absorb the wetness that remains in the Crosscall TREKKER-M1.
Reassemble the components and turn on the Crosscall TREKKER-M1
When you have completed the previous steps, your Crosscall TREKKER-M1 should be dry. So now you can try to turn on the Crosscall TREKKER-M1. If this does not do the job, we advise you to hang on some days or to bring the Crosscall TREKKER-M1 to a repairman.
What should not be done if perhaps the Crosscall TREKKER-M1 has fallen into the water
You will find a number of stuff not to do when your Crosscall TREKKER-M1 has fallen into the water. The first is to try to turn the mobile back on just after. This can destroy the Crosscall TREKKER-M1. Next, it is strongly advised not to use a heat source to dry the Crosscall TREKKER-M1. In fact, techniques such as oven or hair dryer heat the components and may degrade them. At last, to get the water out of the mobile, do not shake it. Certainly, it could as well damage the Crosscall TREKKER-M1.
