Whether in the wc or in a swimming pool, it from time to time occurs that the Crosscall Element is dropped into the water. Nevertheless, it isn’t because a mobile phone has fallen into the water that it’s obviously dead. Indeed, it is possible to redo an Crosscall Element that has fallen into the water. To do this, it is essential to respect certain steps. People often have bad reflexes and this is what can damage the Crosscall Element. We will 1st discover the methods to be taken after the Crosscall Element has fallen into the water. We will discover in the secondary place the common mistakes that a good number of people make.
Steps to follow if your Crosscall Element fell into the water
In the event that you wish to restore your Crosscall Element in operating order, we advise that you follow the steps below.
Do not attempt to turn the Crosscall Element back on after getting out the water
The first thing to perform when the Crosscall Element has fallen into the water is to turn off the mobile phone. Indeed, if it didn’t switch off, turn it off without doing any other tricks. In cases where it is already off, do not attempt to turn it back on for the moment. In cases where the Crosscall Element is switched on and wet, you could generate a short circuit and therefore toast the mobile phone.
Remove detachable components
Once the Crosscall Element is out of the water and turned off, it will have to be disassembled to the highest possible. Meaning that it will probably be essential to remove the shell, the SIM card, the SD card and the battery if possible. Once performed, put all of these items to dry and proceed to the following step.
Aspire the water that is in your Crosscall Element
Using a straw, you must suck up the water that is contained in your Crosscall Element. For this, you simply need to glue the straw over areas like buttons and vacuum. Once you think you have aspired all the water from your Crosscall Element, you will have the ability to start drying it.
Dry the Crosscall Element
The fourth step is to dry the mobile phone. For this, we advise you to put it in front of a ventilator a number of hours. Prevent using méthodes that cause the mobile phone to heat up or damage the mobile phone. Once it is done, we advise you to leave the Crosscall Element in rice for 24 or 48 hours. The rice will therefore absorb the moisture that stays in the Crosscall Element.
Reassemble the components and turn on the Crosscall Element
When you have completed the prior steps, your Crosscall Element should be dry. So now you can make an attempt to turn on the Crosscall Element. If this doesn’t work, we advise you to hang on a few days or to bring the Crosscall Element to a repairman.
What should not be done if the Crosscall Element has fallen into the water
You will find a number of points not to perform when your Crosscall Element has fallen into the water. The 1st is to make an attempt to turn the mobile phone back on just after. This can demolish the Crosscall Element. Next, it is highly advised not to use a heat source to dry the Crosscall Element. Without a doubt, methods which include oven or hair dryer heat the components and may damage them. Finally, to get the water out of the mobile phone, do not shake it. In fact, it could additionally ruin the Crosscall Element.
